SWT-632 type comprehensive eddy current testing machine is a full-automatic eddy current testing equipment on looking for flaw and sorting about hardness on workpiece for cylindrical metal parts .it is specially apply to one hundred percent testing about cylindrical metal parts.
SWT-632 Eddy Current Non Destructive Testing Instruments of Tubes is a full-automatic eddy current testing equipment on looking for flaw and sorting about hardness on workpiece for cylindrical metal parts .it is specially apply to one hundred percent testing about cylindrical metal parts.
1.It adopts double frequency and double channel to test workpiece.
2.Searching flaw and hardness sorting will be finished in one process.
3.It can test flaw in the depth 0.05mm.
4.The speed of testing is lower than one piece in two seconds.
5.Equipment noise< 60dB. Power consumption < 500W / 220V.
6.Supplying sorting and counting automatically.
7.The parts are not damaged after eddy current flaw detector.
8. It does not need to be washed、demagnetized after testing.
9.Count up the number of all workpiece and qualified products and percent of pass.
1. Frequency range: 64Hz-2MHz.
2.Gain amount: 0-48db, stepping is 0.5dB.
3.Phase position: 0-360 degrees, 1 degree step.
4.Independent optional frequency.
5.Different style model setting.
6.Automatic phase position ,amplitude analyzing function.
7. Automatic zero calibration system,it can set time interval of zero calibration.
8.Different styles alarm area setting , it can be applied to every modes.
9.Ratio of gains(Y/X): 0.1-10.
10.Clear screen automatically /tracking impedance.
11.It can test signal playback ,saving and so on.
12.Fast simulation /digital electric automatic balance and dynamic tracking smoothing.
13.Operating interface is simple and intelligent ,very easy to oiperate.
14It is suitable for every probe: external through type.
15.It suitable for metal tube ,rods production and offline quality testing.
17.Unequal amplitude 、Dissymmetrical phase position alarm area setting.
18.Many kinds of showing ways: impedance time base.
20.Voice light alarm output.
21.Automatic balanced time.
22.Inside and outside clock selection.
23.It can save all kinds of testing procedures and testing database.
24.The eddy current signal can playback or extend.
25.Recording showing flaw automatically.
26.Showing ways: full line , blanking.
27.blanking Showing coefficient: 1～100.
28.Background option from rectangular coordinate system and polar coordinate system.
29.Calendar and time showing.
30.Liquid crystal displayer.
31.Simulating electric balance.
32.Testing amplitude 、phase position ,digital value of flaw.
Saving temperature ：-20~60℃
Relative humidity: not exceed eighty-five percent
a corner of flaw detection:
a corner of flaw detection: